Printers
555-233-116
114 Issue 4 October 2002
Administering adjunct parameters
You must administer adjunct parameters to let the system know that the adjunct is
connected through TCP/IP.
PMS journal and PMS log printers
1. Type change system-parameters hospitality and press RETURN.
The Hospitality screen appears.
2. On this screen, you can administer the PMS Log En dpoint (PMS_LOG) or
PMS Journal Endpoint (PMS_JOURNAL) for whichever of these is
connected through TCP/IP.
3. In the PMS Log Endpoint field, type CDR1. If you use a secon dary output
device, and that device is also connected through TC P/IP, type CDR2 in
the Secondary Output Endpoint field.
4. Press ENTER to save your changes.
System printer
1. Type change system-parameters features and press RETURN.
The Feature-Related System Parameters screen appea rs.
2. Move to Page 4.
3. In the System Printer Endpoint field, type SYS_PRNT.
4. Press ENTER to save your changes.
Testing the switch-to-adjunct link
You can use the test, status, busyout and release commands for to find and
correct problems with system printer, PMS log printer, or PMS journal printer. For
more information about these commands, see the M aintenance manual for your
switch.
If a link does not come up immediately, try using the busyout (journal-link pms-log
and wakeup-log, and sp-link) and release (journal-lin k pms-log and wakeup-log,
and sp-link) commands.
NOTE:
Status sp-link can show a system printer link as down, when it is actually
properly connected. If no data is being transmitted, the switch may not see
this link as active.