Malicious call trace

NOTE:

A wiring block must be locally engineered.

NOTE:

909A couplers ships with one DW4B-DE cable and two DW8B-SE cables. The 909B ships with one KS-22911L2 power supply, one DW4B-DE cable, and two DW8B-SE cables.

1.Determine the port assignment of the recorder from the malicious call tracing form.

2.Install the 909A/B universal coupler on a vertical surface.

3.Connect the SZ, SZ1, S, and S1 leads from the 909A/B to an auxiliary trunk circuit pack.

a.Tip and ring connect from the voice recorder to the auxiliary trunk circuit pack (J1 on the 909A/B).

b.CBS1/C1 and CBS2/C2 connect from the voice recorder to J2 on the 909A/B.

4.On the 909A/B universal coupler:

a.Connect seizure control voltage of from -9 to -70 Volts to the PG2/ BZ2 connection (pin 2 of J1). Switching voltage to the PG2/BZ2 connection can be from the 909A/B -48 VDC supply.

b.Connect SZ1 to the ground lead of the DC power source used for PG2/BZ2.

c.Set S1 to the “C2” position. Set S2 position 7 to “OPEN”.

d.Connect an approved -48 VDC power source to the -48and GRD terminals (pins 5 and 2, respectively, of J3 on the 909A/B).

5.Administer the switch for the call trace device.

190 Issue 4 October 2002

555-233-116

Page 190
Image 190
Avaya 555-233-116 manual