Multimedia call handling (MMCH)

9.Set the Interface: field to network

10.Set the Country Protocol:field to 1

11.Set the Protocol Version:field to a

12.Set the CRC?:field to y

13.The Idle Code default is 11111111.

14.The DCP/Analog Bearer Capability default is 3.1 kHz.

15.Set the MMI Cabling Board: field to xxxxx (where xxxxx is the location of the TN787F/H/J/K MMI circuit pack recorded in step 2). This must be the slot for port B of the Y-cable.

16.The MMI Interface: field ESM appears.

17.Enter add signaling-group next and the signaling-group form appears.

18.Change Associated Signaling: field to y.

19.Change Primary D-Channel Port: field to xxxx17 (where xxxx is the

address of the TN2207 PRI circuit pack, for example: 1B0517).

20.The Max Number of NCA TSC: default is 0.

21.The Max Number of GA TSC: default is 0.

22.Trunk Group for NCA TSC: ____ (leave blank)

23.Trunk Group for Channel Selection:____ (leave blank)

24.Logoff the terminal and then log back on the terminal to view your changes.

Place test call

Place multimedia data-conference call to an endpoint with known video capability to test the esm function.

Troubleshooting

To determine ESM link status enter the following commands from the system administration terminal:

1.Status esm

2.Status signaling-group

3.List MMI

NOTE:

When you move ESM circuit packs, you MUST remove the DS1 and signaling group translations. You cannot use the change circuit pack command.

Refer to ‘‘Setup and test the MMCH installation’’ on page 214 for further information.

555-233-116

Issue 4 October 2002 223

Page 223
Image 223
Avaya 555-233-116 manual Place test call, Troubleshooting, Status esm Status signaling-group List MMI