Avaya 555-233-116 Enabling test mode on 7400A DCE, Exiting menus and saving changes on 7400A DCE

Data modules and asynchronous data units

Enabling test mode on 7400A DCE

The test-mode (pin 25) setting can have either of two values: ON or OFF (the default).

1.Accept the default values, unless otherwise instructed. When the SET TM LEAD? prompt appears, press the NEXT/NO button to keep the default, ON.

SET TM LEAD?
	DATA	NEXT/NO	BACK	ENTER/YES
	●	➜ ●	❍	❍

Push the button indicated by the arrow (➜ )

Exiting menus and saving changes on 7400A DCE

1. When the DONE? prompt appears, press the ENTER/YES button.

DONE?
	DATA	NEXT/NO		BACK	ENTER/YES
	●		❍	❍	➜ ●
Push the button indicated by the arrow (➜ )

2.When the SAVE CHANGES? prompt appears, press the ENTER/YES button.

	SAVE CHANGES?
		DATA	NEXT/NO		BACK	ENTER/YES
		●		❍	❍	➜ ●
	Push the button indicated by the arrow (➜ )
Your changes are saved.
	CHANGES SAVED
		DATA	NEXT/NO		BACK	ENTER/YES
		●		❍	❍	➜ ●

Push the button indicated by the arrow (➜ )

68 Issue 4 October 2002 555-233-116