Paging and announcement equipment
555-233-116
206 Issue 4 October 2002
Loudspeaker paging for G700 Media Gateways
On a G700 Media Gateway, the loudspeaker paging feature is connected through
a port on an MM711 Analog Media Module.
The G700 Media Gateway does not support an auxilia ry trunk circuit pack.
Therefore, the loudspeaker feature through an auxilia ry trunk is not supported on
a G700 Media Gateway. However, ECC G700 Media Gateway users can access
the loudspeaker paging feature if equipment is phy sically connected to a TN763
auxiliary trunk circuit pack in an EPN carrier of an ECC system.
Figure 54 shows the connections for loudspeake r paging, dial dictation, or
recorded announcement features on a G700 Media Gatew ay.
Figure 54. Typical loudspeaker equipment connections for a G700 Media Gateway
To hook up loudspeaker paging from a G700 Media Gateway:
1. Connect one end of an RJ-45 cable to a port in the MM711 Analog Media
Module.
2. Connect the other end of the RJ-45 cable to a customer-sup plied
telephone hybrid device.
3. Follow the manufacturer’s instructions to properly c onnect the telephone
hybrid device to your loudspeaker paging system.
4. Administer the switch for the new equipment.
1. G700 Media Gatewa y
2. MM711 Analog Media Module
3. RJ-45 conn ection
4. Telephone hybrid (third party) device
5. Loudspe aker paging system
cydfspkKLC 091802
ALM
TST
ACT
123456 87
ALM
TST
ACT
123456 87
REMOVE
ALM
TST
ACT
OKTO SHUTDOWN
SERVICES USB1 USB2
E1/T1 EIA 530A DCE
ALM
TST
ACT
SIG
EISO EMSM EOSI
12
4
3
5