| E1/T1 Port Configuration |
Table 31: E1/T1 Port Configuration Parameters (continued) | |
|
|
Field | Description |
|
|
Cablelength (T1 | The recommended maximum cable length. |
only) |
|
Gain (T1 only) | The gain on this interface. Gain represents the level of signal boost |
| required to transmit across the circuit at the maximum cable length. |
|
|
Clock Source | The source of the Transmit Clock. Possible sources include: |
| ● Line - The recovered receive clock is used as the transmit clock. |
| ● Internal - The local clock is used as the transmit clock. |
|
|
FDL (T1 only) | The type of FDL used on this interface. Possible types include: |
| ● ANSI |
| ● AT&T |
| ● Both - ANSI and AT&T FDL are both used on this interface. |
| ● None - FDL is not used on this circuit. |
|
|
Local Loopback | A request to use a local loopback. A local loopback can be performed |
| using: |
| ● No Loopback |
| ● Payload Loopback |
| ● Line Loopback |
| ● Diag Loopback |
|
|
Remote | A request to use a remote loopback. A remote loopback can be performed |
Loopback | using: |
(T1 only) | ● No Remote Loopback |
| ● Remote Line |
| ● Reset Remote Loopback |
|
|
Loopback | The type of loopback currently used by the port. Possible values are: |
Status | ● No Loopback |
| ● Near End Payload |
| ● Near End Line |
| ● Near End Inward |
| ● Far End Payload |
| ● Far End Line |
|
|
Fault Messages | Any faults that occurred on the port. |
|
|
| 2 of 2 |
|
|
Issue 5 October 2007 89