Chapter 14: Trap Managers Configuration

This chapter provides the information and instructions for configuring trap managers for the Avaya G250/G350/G450 Device. It includesthe following sections:

Trap Manager Overview - An overview of trap managers.

Configuring Trap Managers - Instructions on accessing the device’s Trap Managers Table, and a description of the Trap Managers Table.

Editing the Trap Managers Table - Instructions on how to edit the Trap Managers Table.

Trap Manager Overview

In the event of a fault or an unusual occurrence, the Avaya G250/G350/G450 Device can send traps to one or more Network Management Stations (NMS). To enable this feature, you must configure the Avaya G250/G350/G450 Device with a list of the managers’ workstations. Traps are then sent to the stations listed in the Managers table.

Note:

Up to nine managers can be assigned per device. However, it is recommended to keep the list limited to actual and relevant managers so as not to place undue stress on the network.

Using the Trap Managers Table, you can also configure which traps are sent. Checking the checkbox for a trap enables the manager to receive the checked trap. Managers only receive the traps which are checked.

Issue 5 October 2007 203

Page 203
Image 203
Avaya G250, G450 manual Trap Managers Configuration, Trap Manager Overview