4-12

Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter4 IP Networking
ONS 15454 IP Addressing Scenarios
Figure4-9 Scenario 7: OSPF not enabled

Use the following procedure to enable OSPF on each ONS 15454 node that you want included in the

OSPF network topology. ONS 15454 OSPF settings must match the router OSPF settings, so you will

need to get the OSPF Area ID, Hello and Dead intervals, and authentication key (if OSPF authentication

is enabled) from the router to which the ONS 15454 netwo rk i s co nne cte d b efor e en ab lin g OSPF.

Procedure: Set up OSPF
Step 1 Log into the ONS 15454 node.
Step 2 In node view, select the Provisioning > Network > OSPF tabs. The OSPF pane has several options

(Figure 4-10).

CTC Workstation
IP Address 192.168.1.100
Subnet Mask 255.255.255.0
Default Gateway = 192.168.1.1
Host Routes = N/A
Router
IP Address of interface “A” to LAN A 192.168.1.1
IP Address of interface “B” to LAN B 192.168.2.1
Subnet Mask 255.255.255.0
Static Routes = Destination 192.168.3.20 Next Hop 192.168.2.10
Destination 192.168.4.30 Next Hop 192.168.2.10
ONS 15454 #2
IP Address 192.168.3.20
Subnet Mask 255.255.255.0
Default Router = N/A
Static Routes = N/A
ONS 15454 #1
IP Address 192.168.2.10
Subnet Mask 255.255.255.0
Default Router = 192.168.2.1
Static Routes
Destination = 192.168.1.100
Mask = 255.255.255.255
Next Hop = 192.168.2.1
Cost = 2
ONS 15454 #3
IP Address 192.168.4.30
Subnet Mask 255.255.255.0
Default Router = N/A
Static Routes = N/A
LAN B
LAN A
Int "A"
Int "B"
SONET RING
33161