7-15
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter7 Card Provisioning
Provisioning Electrical Cards
Step 2 Click the Provisioning tab.
Step 3 Depending on the setting you need to modify, click the Line, Thresholds, or STS subtab.
Note See Chapter1 0, “Alarm Monito ring and Ma nagement ” for information about the Alarm
Behavior tab.
Step 4 Modify the settings shown in Tab le 7-6. For drop-down lists, select an item from the list. For numerics,
double-click the field and type the new number.
Table7-6 EC1-12 Card Parameters
Subtab Parameter Description Options
Line Port # EC-1 card port # 1 - 12
Port Name Name assigned to the port
(optional) To enter a name for the port, click
the cell and type the name. To
change a name, double-click the
cell, then edit the text.
PJStsMon# Sets the STS that will be used
for pointer justification. If set to
zero, no STS is used. See the
“Pointer Justification Count
Parameters” section on
page 8-12 for more information.
•0 (default)
•1
Line Buildout Defines the dista nce (in feet )
from backplane to next
termination point
•0 - 225 (default)
•226 - 450
Rx
Equalization For early EC1-12 card versions,
equalization can be turned off if
the line length is short or the
environment is extremely cold;
Rx Equalization should
normally be set to On
•On (checked, default)
•Off (unchecked)
Status Places the port in or out of
service •Out of Service (default)
•In Service