1-47
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter1 Hardware Installation
Card Installation
* When used as a protect card, the card does not have a physical external connection. The protect card connects to the working
card(s) through the backplane and becomes active when the working card fails. The protect card then uses the physical
connection of the failed card.
Procedure: Install the TCC+ and XC/XCVT/XC10G Cards
Although the installation procedure is the same for both TCC+ and XC/XCVT/XC10G cards, you must
install the TCC+ card and let it initialize before installing the XC/XCVT/XC10G cards. The TCC+ card
houses the ONS 15454 software. For a detailed explanation, see Chap ter 2, “Software Installation.”
Note This is not the procedure to use when upgrading from XC to XCVT cards or from X C V T to XC10G
cards. If you are performing an XC to XCVT upgrade, an X CVT t o a XC 10G up gr ade, or a TCC to
TCC+ upgrade, refer to the Cisco ONS 15454 Troubleshooting and Maintenance Guide.
Step 1 Open the card ejectors.
Step 2 Slide the card along the guide rails into the correct slot (Slot 8 or 10 for the XC/XCVT/XC10G and Slot
7 or 11 for the TCC+).
Step 3 Close the ejectors.
Step 4 Verify that power is applied to the shelf assembly.
Step 5 Verify the LED activity as described in Table 1-9.
DS3N-12E 12 44.736 Mbps SMB or BNC* —
DS3XM-6 6 44.736 Mbps SMB or BNC* Backplane
EC1-12 12 51.84 Mbps SMB or BNC* Backplane
E100T-12 12 100 Mbps RJ-45 Face plat e
E1000-2 2 1000 Mbps SC (GBIC) Faceplate
E100T-G 12 100 Mbps RJ-45 Faceplate
E1000-2-G 2 1000 Mbps SC (GBIC) Facepl at e
OC-3 IR 4 155.52 Mbps (STS-3) SC Faceplate
OC-12 (IR/LR) 1 622.08 Mbps
(STS-12) SC Faceplate
OC-48
(IR/LR/ELR) 1 2488.32 Mbps
(STS-48) SC Faceplate
OC-48 any slot
(IR/LR) 1 2488.32 Mbps
(STS-48) SC Faceplate
OC-192 (LR) 1 9.95 Gbps (STS-192) SC Faceplate
Table1-8 Card Ports, Line Rates, and Connectors (continued)
Card Ports Line Rate per Port Connector Types
Connector
Location