6-23
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter6 Circuits and Tunnels
Creating DCC Tunnels
Figure6-16 Selecting DCC tunnel end points
Step 5 Click OK.
Step 6 Put the ports hosting the DCC tunnel in service:
a. Double-click the card hosting the DCC in the shelf graphic or right-click the card on the shelf
graphic and select Open.
b. Click the Provisioning > Line tabs.
c. Under Status, select In Service.
d. Click Apply.
DCC provisioning is now complete for one node. Repeat these st eps for all slot s/po rts tha t a re pa rt o f
the DCC tunnel, including any intermediate nodes that will pass traffic from third party equi pment. T he
procedure is confirmed when the third-party network el eme nts su cce ssfu lly c omm unic ate ove r the
newly-established DCC tunnel.