9-13
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter9 Ethernet Operation
Ethernet Circuit Configurations
Step 27 Click the green span leading to the next node.
The span turns white.
Step 28 Click Add Span.
The span turns blue.
Step 29 Repeat Steps 24 – 27 for every node remaining in the ring. Figure9-13 shows the Circuit Path Selection
dialog box with all the spans selected.
Figure9-13 Viewing a span
Step 30 Verify that the new circuit is correctly configured.
Note If the circuit information is not correct, click the Back button and repeat the procedure with
the correct information. You can also click Finish, delete the completed circuit, and begin
the procedure again.
Step 31 Click Finish.
Step 32 You now need to provision the Ethernet ports and assign ports to VLANs. For port provisioning
instructions, see the “Provision Ethernet Ports” procedure on page9-3. For assigning port s to VLANs,
see the “Provision Ethernet Ports for VLAN Membership” procedure on page 9-24.