4-15
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter4 IP Networking
Viewing the ONS 15454 Routing Table
Dead Int (sec)Sets the number of seconds that will pass while an OSPF routers packets are not
visible before its neighbors declare the router down. Forty seconds is the def ault.
c. Click OK.
Step 9 After entering ONS 15454 OSPF area data, click Apply.
If you changed the Area ID, the TCC+ cards will reset, one at a time.
4.3 Viewing the ONS 15454 Routing Table
ONS 15454 routing information is displayed on the Maintenance > Routing Table tabs (Figure 4-11).
The routing table provides the following information:
DestinationDisplays the IP address of the destination network or host.
MaskDisplays the subnet mask used to reach the destination host or net work.
GatewayDisplays the IP address of the gateway used to reach the destination network or host.
UsageShows the number of times this route has been used.
InterfaceShows the ONS 15454 interface used to access the destination. Values are:
cpm0the ONS 15454 Ethernet interface, that is, the RJ-45 jack on the TCC + and t he LA N 1
pins on the backplane.
pdcc0an SDCC interface, that is, an OC-N trunk card identified as the SDCC termination.
lo0a loopback interface