Cisco Systems 15454M6DC Procedure: Provision an EtherSwitch Point-to-Point Circuit (Multicard or Single-Card)

9-7
Cisco ONS 15454 Installation and Operations Guide
November 2001
Chapter9 Ethernet Operation
Ethernet Circuit Configurations
Figure9-5 A Multicard EtherSwitch point-to-point circuit
Figure9-6 A Single-card Etherswitch point-to-point circuit
Procedure: Provision an EtherSwitch Point-to-Point Circuit (Multicard or Single-Card)
Step 1 Display CTC for one of the ONS 15454 Ethernet circuit end poi nt nod es.
Step 2 Double-click one of the Ethernet cards that will carr y the c ircu it.
Step 3 Click the Provisioning > Card tabs.
Step 4 If you are building a Multicard Etherswitch point-to-point circuit:
a. Under Card Mode, verify that Multi-card EtherSwitch Group is checked.
b. If Multi-card EtherSwitch Group is not checked, check it and click Apply.
c. Repeat Steps 2 – 4 for all other Ethernet cards in the ONS 15454 that will carry the circuit.
If you are building a Single-card Etherswitch circuit:
d. Under Card Mode, verify that Single-card EtherSwitch is checked.
e. If Single-card EtherSwitch is not checked, check it and click Apply.
43272
ONS 15454
#1
ONS 15454
#2
192.168.1.100
255.255.255.0
VLAN test 1
Slot 5, port 1
192.168.1.75
255.255.255.0
VLAN test 1
Slot 17, port 1
192.168.1.25
255.255.255.0
VLAN test 1
Slot 4, port 1
192.168.1.50
255.255.255.0
VLAN test 1
Slot 15, port 1
ONS 15454
#3
SONET
Ethernet
ONS 15454
#3
ONS 15454
#2
ONS 15454
#1
192.168.1.50
255.255.255.0
VLAN test
Slot 15
192.168.1.25
255.255.255.0
VLAN test
Slot 4
32161