Cisco Systems MDS 9500 Series manual LEDs on IP Storage Services Modules

Chapter 1 Product Overview

Services Modules

Se n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a ck - d o c @ c i s c o . c o m .

Figure 1-30shows the IPS-4 services module.

Figure 1-30 Cisco MDS 9000 Family IPS-4 Services Module

2

1

LINK

1

2 3

LINK LINK

3

4

LINK

113161

4

1	Status LED	3	Link LEDs
2	Gigabit Ethernet ports	4	Asset tag

LEDs on IP Storage Services Modules

Table 1-17describes the LEDs for the IPS services modules.

	Table 1-17		LEDs for the Cisco MDS 9000 Family IPS Module
	LED	Status		Description
	Status	Green		All diagnostics pass. The module is operational (normal initialization sequence).
		Orange		One of the following occurs or occurred:
				• The module is booting or running diagnostics (normal initialization
				sequence).
				• The inlet air temperature of the system exceeded the maximum system
				operating temperature limit (a minor environmental warning). To ensure
				maximum product life, you should immediately correct the environmental
				temperature and restore the system to normal operation.
		Red		One of the following occurred:
				• The diagnostic test failed. The module is not operational because a fault
				occurred during the initialization sequence.
				• The inlet air temperature of the system exceeded the safe operating
				temperature limits of the card (a major environmental warning). The card shut
				down to prevent permanent damage.
	Link	Solid		Link is up.
		green
		Flashing		Link is up (beacon used to identify port).
		green
		Solid		Link is disabled by software.
		yellow
		Flashing		A fault condition exists.
		yellow
		Off		No link.
				Cisco MDS 9500 Series Hardware Installation Guide
OL-17467-02					1-47