Cisco Systems MDS 9500 Series manual LEDs on the MPS-14/2 Module

Chapter 1 Product Overview

Services Modules

Se n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a ck - d o c @ c i s c o . c o m .

Figure 1-28shows an MPS-14/2 module.

Figure 1-28 Cisco MDS 9000 Family MPS-14/2 Module

									2						4
														1	2
														LINK-	LINK-
1	2	3	4		5	6	7	8	9	10	11	12	13	14
STATUS														GIGABIT E THERNET
LINK—			—SPEED	LINK—					—SPEED	LINK—				—SPEED
1									3					5	6	116889

1	Status LED	4	Gigabit Ethernet ports
2	1-Gbps/2-Gbps Fibre Channel ports	5	Link LEDs
3	Link LEDs (under ports, on left) and Speed LEDs	6	Asset tag
	(under the ports, on the right)

LEDs on the MPS-14/2 Module

Table 1-16describes the LEDs for the MPS-14/2 modules.

Table 1-16		LEDs for the Cisco MDS 9000 Family MPS-14/2 Modules
LED	Status		Description
Status	Green		All diagnostics pass. The module is operational (normal initialization sequence).
	Orange		One of the following occurs or occurred:
			• The module is booting or running diagnostics (normal initialization sequence).
			• The inlet air temperature of the system exceeded the maximum system
			operating temperature limit (a minor environmental warning). To ensure
			maximum product life, you should immediately correct the environmental
			temperature and restore the system to normal operation.
	Red		One of the following occurred:
			• The diagnostic test failed. The module is not operational because a fault
			occurred during the initialization sequence.
			• The inlet air temperature of the system exceeded the safe operating temperature
			limits of the card (a major environmental warning). The card shut down to
			prevent permanent damage.
Speed	On		2-Gbps mode.
	Off		1-Gbps mode.

Cisco MDS 9500 Series Hardware Installation Guide

OL-17467-02 1-45