
Chapter 2 Installing the Cisco MDS 9500 Series
Removing, Installing, and Verifying Supervisor, Switching, and Services Modules
Se n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a ck - d o c @ c i s c o . c o m .
Figure 2-23 Clearing the EMI Gasket
Press down gently
4
SWITCH FABIRD MDL 6
Press down
gently
91690
1mm Amount of gap between the module EMI gasket and the module above it
b.Grasp the two ejector levers using the thumb and forefinger of each hand, and press down to create a small
| Cisco MDS 9500 Series Hardware Installation Guide |