Cisco Systems MDS 9500 Series manual Repeat and to remove any additional clock modules

Chapter 2 Installing the Cisco MDS 9500 Series

Removing and Installing Clock Modules

Se n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a ck - d o c @ c i s c o . c o m .

Note Note the position and orientation of the clock module before you remove it from the director chassis because you must install the new clock module in the same position.

Step 3 Verify the LEDs on the clock modules.

Step 4 Disconnect and gently remove the module, placing it on an antistatic mat or foam. (See Figure 2-41.)

Figure 2-41 Clock Module Replacement on the Cisco MDS 9513 Director (Rear View)

Sheet metal

side

Component

side

144602

Step 5 Repeat Step 3 and Step 4 to remove any additional clock modules.

	Cisco MDS 9500 Series Hardware Installation Guide
2-78	OL-17467-02