Enabling the Privileged-Access Password
Before you begin:
Read “Safety Considerations” on page 4-2 and “Handling Static Sensitive
Devices” on page 4-3.
Remove the system unit cover (see “Removing the Cover” on page 4-4).
To enable the privileged-access password, you must first change the jumper on the
system board which blocks the use of the privileged-access password.
This procedure should only be performed one time.
1. Remove the disk drive bracket assembly from the system unit and carefully place
it on top of the power supply.
Note: Any adapters installed in slot 5 may have to be temporarily removed in
order to remove the disk drive bracket. Refer to “Removing Adapters” on
page 4-80 for adapter removal instructions.
4-14 7043 43P Series User's Guide