4. If you have a Model 240:
a. Locate jumper J32 using the following illustration.
b. To enable or change the privileged-access password, first to frame of the system unit, then gently pull upward on the smal covering the pins. Replace the jumper so that it covers the instead of the right two.
5. Reinstall any adapters you have removed.
6. To set the privileged-access password, you must first install all (such as internal drives, memory, adapters) if you are planning t now. After you have installed these options and replaced the co system unit, start the System Management Services to set the priv password. For more information on the System Management Services, se Chapter 3, “System Management Services” on page 3-1.
Chapter 4. Installing and Removing4-17Options
