IBM RS/6000 7043 43P manual Pow

Press Enter when you are finished; you must type the password again for verification.

If you make a mistake, Escpresskey theand start again.

After you have entered and	verified	the password, the power-on password
icon flashes and changes to	the locked	position	to	indicate	that	the	pow
password is installed.
If you previously had set	a power-on	password	and	want to	remove	it,	se
Remove icon.

Notes:

1. If you want to disable an installed power-on password (but not erase power-on password jumper as described in the section beginning on 4-9. Moving the jumper back to the default position re-enables the power-on password, unless it has been removed in the System Management Services Utilities or by removing the battery.

2. If forgetyou the power-on		password,		you	can	erase	the	password	by	shutt
down the	system unit	and	removing	the battery			for	at least	30	seconds
“Changing	the Battery”	on	page 4-108		for	details.

3. The system unit powermustcablebe disconnected before removing the battery

A password becomes effective only after the system is turned off and

3-147043 43P Series User's Guide