that | the | new | disk | drive | SCSI | address |
| must be | set to an address that i | ||||||||||
in use and the drive be installed in an empty | location. If there are no | ||||||||||||||||||
locations, | then |
| one | of | the | other | drives must be removed. Once the copy | ||||||||||||
complete, | only | one | drive | may | remain | installed. Either | remove | the target | dri | ||||||||||
return | to | the |
| original | configuration, or | perform | the | following procedure to | |||||||||||
the | replacement | of | the | old | drive | with | the | new | drive. |
|
|
| |||||||
1. Remove | both | drives. |
|
|
|
|
|
|
|
|
|
|
|
| |||||
2. | Set | the SCSI address | of | the | new | drive | to | the | SCSI address | of | the | ||||||||
3. | Install | the |
| new | drive | in | the | old | drive's | location. |
|
|
| ||||||
4. | Install | any |
| other | drives | that | were | removed | into | their | original | location | |||||||
To prevent problems that may occur when running this service aid from disk suggested that this service aid be run from the diagnostics that are l removable media when possible.
Display/Alter Sector
This | selection allows the user to | display | and alter information on a | disk | |||||
must | be | used when using this service | aid | because | inappropriate modificat | ||||
some disk sectors may result in total | loss of all data on the disk. | Secto | |||||||
addressed by their decimal sector number. Data | is | displayed both | in | he | |||||
ASCII. To prevent corrupted data from | being incorrectly corrected, | the | s | ||||||
does | not | display information that | cannot | be | read | correctly. |
|
| |
Display Configuration and Resource List
This service aid displays the item header only for all installed resource service aid when there is no need of seeing the VPD. (No VPD is displa
Display Firmware Device Node Information
Note: Runs on CHRP systems units only.
This task displays the firmware device node information that appears on CH platforms. The format of the output data may not be the same between d levels of AIX. It is intended to gather more information about individual devices on the system.
Display Hardware Error Report
This service aid provides a tool for viewing the hardwareerrpt error log. It command.
