ŸEnable/disable surveillance
Ÿ Set the surveillance time interval, in minutes
ŸSet the surveillance delay, in minutes
The current settings are read from NVRAM and displayed on the screen. Any changes made to the data shown are written to NVRAM.
Modem Configuration
Use this selection when setting the NVRAM for a modem attached to any o Service Processor's serial ports. The user inputs the file name of a mode configuration file and the serial port number. The formatted modem configur is read, converted for NVRAM than loaded into NVRAM. Refer to the "Servic Processor Installation and User's Guide" for more information.
Call In/Out Setup
This selection allows the user to display and change the NVRAM settings fo In/Call Out capability of the service processor.
The settings allows the user to:
Ÿ | Enable/Disable | call | in | on | either | serial | port. |
Ÿ | Enable/Disable | call | out | on either serial | port. | ||
Ÿ | Set the line | speed | on | either | serial port. |
Site | Specific | Call | In/Out | Setup |
|
|
|
This | selection | allows | you | to display and change | the | NVRAM settings that ar | |
specific | for | the call | in/call out capability of | the | service processor. |
The site specific NVRAM settings allow you to:
Ÿ | Set | the | phone number for the service center | ||||
Ÿ | Set | the | phone | number for the customer administration center | |||
Ÿ | Set | the | phone number for a digital pager | ||||
Ÿ | Set | the | phone | number for | the customer system to call in | ||
Ÿ | Set | the | phone number for the customer voice phone | ||||
Ÿ | Set | the | customer | account number | |||
Ÿ | Set | the | call out | policy |
|
| |
Ÿ | Set | the | customer | RETAIN | id |
| |
Ÿ | Set | the | customer | RETAIN | password | ||
Ÿ | Set | the | remote | timeout | value | ||
Ÿ | Set | the | remote | latency | value | ||
Ÿ | Set | the | number | of | retries | while busy |