Icom IC-7000 instruction manual Memory programming, Programming in VFO mode

8MEMORY OPERATION

■Memory programming

Memory channel programming can be performed ei- ther in VFO mode or in memory mode.

Menu group selection

Push [MENU/GRP] for 1 sec.

Selection from: M, S or G(Graphic)

Menu selection (Example: M)

Push [MENU/GRP] momentarily.				Either
Selection from:	,	or		Y or Z
	M-1 M-2		M-3

DProgramming in VFO mode

q Push [PBT/M-ch/RIT]momentarily to select the M- ch/RIT function, if the twin PBT is selected.

• [PBT/M-ch/RIT]indicator (Green) goes out.

w Set the desired frequency and operating mode in VFO mode.

•If you want to program the split frequency function, pro- gram both receive and transmit frequencies into VFO A and B, then turn ON the split function. (p. 91)

•If you want to program a repeater function, set a tone frequency (p. 60) in addition to the receive/transmit fre- quencies.

e Select the menu M-2.

r Push [F-1MEM] to display the memory channel contents.

•Memory channel contents appear above the multi-func- tion key indicator.

•Push [F-1LST] to display the memory channel list. This is convenient for selecting the desired channel. Push [Z(MENU/GRP)] to exit the memory channel list.

t Rotate [M-ch]to select the desired memory chan- nel.

•“ ” and “---,---,--” appear if the selected memory

channel is a blank channel (and does not have con- tents).

•Rotating [RIT] (outer) control changes the bank.

y Push [F-2MW] for 1 sec. to program the displayed frequency and operating mode into the selected memory channel.

To check the programmed contents, push [F-4V/M] to select memory mode.

[PBT/M-ch/RIT] switch/[M-ch] (inner) control
[PBT/M-ch/RIT] indicator
[MENU/GRP]
[RIT] (outer) control	[F-2]
[EXAMPLE]: Programming 7.088 MHz/LSB into ch 12.

MW

Push for

1 sec.

103