Icom IC-7000 30 HM-151 F-1, 31 HM-151 F-2, MIC Up/Down Speed, Quick RIT/∂TX Clear

13 SET MODE

■Miscellaneous (others) set mode (continued)

30 HM-151 [F-1]

This item programmes for one of several functions to [F-1]key of HM-151. Programmable key assignments are described as below.

MPW	ANF
Memo pad write is pro-	Auto notch filter is pro-
grammed. (default)	grammed.

“P.AMP/ATT” (Preamplifier/attenuator),	“AGC” (AGC selection),
“NB” (Noise blanker),	“TBW” (TX filter width),
“NR” (Noise reduction),	“DUP” (Duplexer),
“MNF” (Manual notch filter),	“TON” (FM tone operation),
“ANF” (Auto notch filter),	“MET” (Meter selection),
“TS” (Tuning step),	“VSC” (Voice squelch control),
“SPL” (Split operation),	“MPW” (Memo pad write),
“A/B” (VCO A/B selection),	“MPR” (Memo pad read),
“MCL” (Memory clear),	“<SCOPE>” (Scope selection),
“BNK” (Bank selection),	“<METER>” (Multi-meter selection)
“COM” (Speech compressor),

31 HM-151 [F-2]

This item programmes for one of several functions to [F-2]key of HM-151. Programmable key assignments are same as above.

MPR	NB
Memo pad read is pro-	Noise blanker function is
grammed. (default)	programmed.

32 MIC Up/Down Speed

This item sets the rate at which frequencies are scanned when the microphone (HM-151) [Y]/[Z] keys are pushed and held. High or low can be se- lected.

HIGH	LOW
High speed (default,	Low speed
50 tuning steps/sec.)	(25 tuning steps/sec.)

33 Quick RIT/∂TX Clear

This item selects the RIT/∂TX frequency clearing in- struction with [F-3CLR] key.

See pgs. 75, 88 for deatails.

ONOFF

Clears the RIT/∂TX fre- Clears the RIT/∂TX fre- quency when [F-3CLR] is quency when [F-3CLR] is

pushed momentarily. pushed and held for 1 sec. (default)

34 SSB/CW Synchronous Tuning

This item selects the displayed frequency shift func- tion from ON and OFF.

When this function is activate, the receiving signal can be kept to receive even when the operating mode is changed between SSB and CW.

The frequency shifting value may differ according to the CW pitch setting.

ONOFF

The displayed frequency The displayed frequency shifts when the operating does not shift.

mode is changed between (default) SSB and CW.

135