Icom IC-7000 Linear amplifier connections, MHz linear amplifier, Connecting the IC-PW1/EURO

2INSTALLATION AND CONNECTIONS

■ Linear amplifier connections	Use the [ANT1] connector when connecting an HF/50
	MHz linear amplifier.

CONNECTING THE IC-PW1/EURO
To an		Remote control cable (supplied with the IC-PW1/EURO)
antenna	ACC-1	ACC cable (supplied with the IC-PW1/EURO)				7-pin side
ANT		REMOTE		OPC-599 conversion cable
						ACC	REMOTE
				INPUT1				GND
		EXCITER				Transceiver		ANT1
		1	1&2			Coaxial cable
						(supplied with the IC-PW1/EURO)
				GND
		IC-PW1/EURO			Ground
AC outlet					)
	Non-European versions: 100–120/220–240 V
(European version			: 230 V

CONNECTING A NON-ICOM LINEAR AMPLIFIER
R WARNING:
•Set the transceiver output power and linear ampli-		•The IC-7000 SEND relay is rated at 16 V and a
fier ALC output level referring to the linear ampli-		0.5 A DC. If these levels are exceeded, a larger
fier instruction manual. Be sure the linear ampli-		external relay must be used.
fier keying circuit control voltage is compatible
with the IC-7000, before connecting to HSEND
line (ACC cable).
•The ALC input level must be in the range 0 V to
–4 V, and the transceiver does not accept positive
voltage. Non-matched ALC and RF power settings
could cause a fire or damage the linear amplifier.
To an	50 1 coaxial cable
antenna
			Transceiver	ANT1
				GND
RF OUT	RF IN	ALC (Blue)
	ALC
	KEY	HSEND	ACC
	Relay	(Orange)		Ground
		13.8V (Gray)	ACC cable

21