Icom IC-7000 instruction manual Transmit Display Scan Problem Possible Cause Solution

15 TROUBLESHOOTING

TRANSMIT

DISPLAY

SCAN

PROBLEM		POSSIBLE CAUSE	SOLUTION	REF.
Transmitting	is impossi-	The operating frequency is not set to	Set the frequency to a ham band.	p. 29
ble.		a ham band.
Output power is too low.		Power is set to a lower power than	Set the output power in quick set	p. 38
		maximum.	mode/initial set mode.
		Microphone gain is set too low.	Set microphone gain to a suitable	p. 38
			position using quick set mode.
		The antenna is not connected properly.	Reconnect the antenna connector.	—
		The antenna feed line is cut or shorted.	Check the feed line and correct any	—
			improper conditions.
		The antenna is not properly tuned.	Push [TUNE/CALL] to manually tune	pgs.
			the antenna.	116, 117
No contact possible with		RIT function is activated.	Push [F-1 RIT] in the RIT/∂TX mode	p. 75
other stations.			to turn the function OFF.
		Split function is activated.	Push [F-1 SPL] in the M-1menu to turn	p. 91
			the function OFF.
Repeater cannot be ac-		Split function is not activated.	Push [F-1 SPL] in the M-1menu to turn	p. 91
cessed.			the function ON.
		An incorrect transmit frequency is set.	Set the proper frequencies into VFO	p. 27
			A and B or into one of the memory
			channels.
		Subaudible tone encoder is OFF and	Use [F-3 TON] in the M-3menu to se-	p. 63
		repeater requires a tone for access.	lect FM-TONE.
		Programmed subaudible tone fre-	Program the required frequency using	p. 64
		quency is wrong.	FM tone set mode.
Transmitted	signals are	Microphone gain is set too high.	Set gain in quick set mode.	p. 38
distorted.		The compression level is set too high	Set compression level to a suitable	p. 89
		with the speech compressor ON.	position.
Displayed	frequency	The dial lock function is activated.	Push [SPCH/LOCK] to deactivate the	p. 37
does not change proper-			function.
ly.		The internal CPU has malfunctioned.	Reset the CPU.	p. 25
			(While pushing [Y(BAND)] and [Z(BAND)],
			push [PWR] to turn power ON.
Programmed scan does		Squelch is open.	Set squelch to the threshold position.	p. 35
not stop.
Programmed scan does		The same frequencies have been	Programm different frequencies into	p. 103
not start.		programmed in scan edge memory	scan edge memory channels.
		channels.
Memory scan does not		2 or more memory channels have not	Program 2 or more memory chan-	p. 103
start.		been programmed.	nels.
Memory select scan		2 or more memory channels have not	Designate 2 or more memory chan-	p. 106
does not start.		been designated as select channels.	nels as select channels for the scan.

141