Icom IC-7000 instruction manual Select memory scan operation, Priority watch

9SCAN OPERATION

Menu group selection

Push [MENU/GRP] for 1 sec.

Selection from: M, S or G(Graphic)

Menu selection (Example: M)

Push [MENU/GRP] momentarily.				Either
Selection from:	,	or		Y or Z
	S-1 S-2		S-3

■Select memory scan operation

q Select S-2.

w Push [F-3V/M] to select memory mode. e Close the squelch with [RF/SQL].

r Push [F-1SCN] to start the memory scan.

•Decimal point blinks while scanning.

t Push [F-2SEL] to change the memory scan to se- lect memory scan.

y When the scan detects a signal, the scan stops or pauses depending on the resume setting.

u To cancel the scan push [F-1SCN].

[RF/SQL]

[MENU/GRP] [F-1] [F-2] [F-3]

NOTE: Two or more memory channels must be

designated as select memory channels for select memory scan to start (see p. 106).

While scan function is not activate, pushing [F-2

SEL] sets the select memory channels ON or OFF.

And pushing and holding [F-2SEL] for 2 sec. clears the all select memory channels.

Select

memory mode.

Designate “★.”

Push [F-1 SCN], then push [F-2 SEL].

■Priority watch

q Select VFO mode, then set a frequency. w Close the squelch with [RF/SQL].

e Set the desired memory channel as the watching channel.

r Select S-2.

t Push [F-2PRI] to start the priority watch.

•“ ” appears and decimal point blink while scanning.

y When the scan detects a signal, the scan pauses for 10 sec. or until the signal disappears, depend- ing on the resume setting.

u To cancel the scan push [F-2PRI].

NOTE: The paused condition when detecting a sig-

nal differs depending on the scan resume condi-

tion. (p 134)

resume on: pauses for 10 sec.

resume off: pauses until the signal disappears.

[RF/SQL]
[MENU/GRP] [F-2]	Appears while scanning

Select

VFO mode.

Select watching channel.

Push [F-2 PRI].

115