Icom IC-7000 instruction manual Rear panel

1PANEL DESCRIPTION

■Rear panel

q	w	e r t	y u i o
KEY	ACC	DATA	MIC
			GND
		ANT2	ANT1
			DC 13.8V

!2

!0

!1

qELECTRONIC KEYER JACK [KEY] (p. 22) Accepts a paddle to activate the internal electronic keyer.

•Selection between the internal electronic keyer and straight key operation can be made in the keyer set mode. (p. 50)

()

When connecting a straight key

	(dot)
When connecting	(com)
	(dash)
a paddle

u RTTY JACK [RTTY] (p. 23)

Connects an external terminal unit for RTTY (FSK) operation.

•The keying polarity, mark/shift frequencies and etc. can be selected in quick set mode (p. 125).

iEXTERNAL SPEAKER JACK [EXT SP] (p. 18) Accepts a 4–8 Ÿ speaker.

oMICROPHONE CONNECTOR [MIC] (p. 17) Accepts the supplied microphone (connected in par- allel with the front panel’s [MIC] connector).

•See p. 2 for microphone notes.

•See p. 10 for microphone connector information.

If you use an external electronic keyer, make sure

the output voltage of the keyer is less than 0.4 V when keying the transmitter.

wACCESSORY SOCKET [ACC] (p. 12)

Enables connection to external equipment such as a TNC for data communications, a linear amplifier or an automatic antenna selector/tuner, etc.

•See page at right for socket wiring information.

eDATA SOCKET [DATA] (p. 12)

6-pin mini-DIN socket to connect a TNC (Terminal Node Controller), etc. for packet operation.

•See page at right for socket wiring information.

rVIDEO OUT JACK [VOUT] (p. 18) Outputs a video signal.

tCI-V REMOTE CONTROL JACK [REMOTE]

(p. 144)

➥Designed for use with a personal computer for re- mote control of the transceiver functions.

➥Used for transceiver operation with another Icom CI-V transceiver or receiver.

yTUNER CONTROL SOCKET [TUNER] (p. 20)

Accepts the control cable from an optional AH-4

HF/50 MHz AUTOMATIC ANTENNA TUNER.

!0GROUND TERMINAL [GND] (p. 15)

Connect this terminal to a station or vehicle ground to prevent electrical shocks, TVI, BCI and other problems.

!1ANTENNA CONNECTOR [ANT1], [ANT2] (p. 17) Accepts a 50 Ÿ antenna with a PL-259 connector.

•[ANT1] is for connection to an HF/50 MHz antenna. •[ANT2] is for connection to an 144/430 MHz antenna. •ANT1 is used below and ANT2 above 60 MHz.

!2DC POWER SOCKET [DC13.8V] (p. 19)

Accepts 13.8 V DC through the supplied DC power cable.

Rear panel view

NOTE: DO NOT use a cigarette lighter socket as a

power source when operating in a vehicle. The plug

may cause voltage drops and ignition noise may be superimposed onto transmit or receive audio.

11