Icom IC-7000 instruction manual Installation, Stand, Front panel separation, Front panel mounting

INSTALLATION AND CONNECTIONS 2

■Installation

DSingle body mounting

Spring washer

MB-62	Nut
(optional)
Supplied with
the MB-62*
Flat washer

*CAUTION: Non-supplied screws (longer than 8 mm) may damage the internal units.

D Stand 2

To raise the stand:

With the transceiver upside down, pull the stand to- wards the rear panel and then upwards, as illus- trated below.

then up

Pull back

DFront panel separation

q While pulling the front panel latch towards you, slide the front panel to the left (fig. 1).

w Attach the optional OPC-1443 to the main body and tighten the supplied screw as in fig. 2.

e Attach the other end of the OPC-1443 to the de- tached front panel as in fig. 3.

CAUTION: NEVER detach/attach the front panel when connecting the DC power supply (or battery).

Be sure to disconnect the DC power cable from the [13.8 V] socket on the transceiver rear panel.

fig. 1	fig. 2	fig. 3
		To remove
		Separation cable
		(OPC-1443)
Latch		Separation cable
		(OPC-1443)

DFront panel mounting

q Attach the MB-105 to a flat surface using the four	fig. 1
supplied screws (fig. 1).
w Fix the detached front panel to the MB-105 as il-
lustrated in fig. 2.
BE CAREFUL to mount the MB-105 so that the
front panel attaches with the correct side up.	fig. 2

16