Icom IC-7000 FIlter passband width setting SSB/CW/RTTY/AM only, If fIlter shape SSB/CW only

FUNCTIONS FOR RECEIVE 5

DFIlter passband width setting (SSB/CW/RTTY/AM only)

q Select SSB, CW, RTTY or AM mode.
•Passband widths for FM and WFM modes are fixed
and cannot be set.
w Select M-1.
•Push and hold [MENU/GRP] for 1 sec. once or twice
to select the menu group M.
•Push [MENU/GRP] momentarily one or more times to
select the menu M-1.	[MENU/GRP] [F-1] [F-2] [F-3]	[DIAL]

5

e Push [F-3FIL] for 1 sec. to enter filter set mode.

Selected IF filter

Passband

width

Shift frequency

r Push [F-3FIL] several times to select the desired

IF filter.

t While pushing [F-1BW], rotate [DIAL] to set the desired passband width.

•The passband width can be set within the range as shown in the table to the right.

•Push [F-2DEF] for 1 sec. to select the default value.

y Repeat steps r to t if desired.

u Push [Z(MENU/GRP)] to exit the filter set mode.

The PBT shift frequencies are cleared when the passband width is changed.

This filter set mode screen graphically displays the PBT shift frequencies.

Mode	Filter	Default	Range (Steps)
	FIL1	3.0 kHz	50–500 Hz (50 Hz)/
SSB	FIL2	2.4 kHz
			600–3.6 kHz (100 Hz)
	FIL3	1.8 kHz
	FIL1	1.2 kHz	50–500 Hz (50 Hz)/
CW	FIL2	500 Hz
			600–3.6 kHz (100 Hz)
	FIL3	250 Hz
	FIL1	2.4 kHz	50–500 Hz (50 Hz)/
RTTY	FIL2	500 Hz
			600–2.7 kHz (100 Hz)
	FIL3	250 Hz
	FIL1	9.0 kHz	200 Hz–10.0 kHz
AM	FIL2	6.0 kHz
			(200 Hz)
	FIL3	3.0 kHz
	FIL1	15 kHz
FM*	FIL2	10 kHz	Fixed
	FIL3	7.0 kHz
WFM	FIL	280 kHz	Fixed

*: When the IF filter is selected FIL2 or FIL3 in the FM mode operation, the Tx IF filter’s passband width is fixed narrow selection (2.5 kHz).

DIF fIlter shape (SSB/CW only)

The type of DSP filter shape for each SSB and CW can be selected independently from soft and sharp.

q Select SSB or CW mode. w Select M-1.

	•Push and hold [MENU/GRP] for 1 sec. once or twice
	to select the menu group M.
	•Push [MENU/GRP] momentarily one or more times to
		[MENU/GRP]	[F-3] [F-4]
	select the menu M-1.
e Push [F-3FIL] for 1 sec. to enter filter set mode.
r Push [F-3FIL] several times to select the desired
IF filter.
t Push [F-4]to select the filter shape from “SHARP”				Push
and “SOFT.”
y Push [Z(MENU/GRP)] to exit the filter set mode.
Specified selectivity (p. 150) is measured with this
parameter set to SHARP.

78