Juniper Networks EX4200, EX3200 manual Connecting a Fiber-Optic Cable to an EX Series Switch

Chapter 11: Connecting the Switch

Connecting a Fiber-Optic Cable to an EX Series Switch

EX Series switches have field-replaceable unit (FRU) optical transceivers to which you can connect fiber-optic cables.

Before you begin connecting a fiber-optic cable to an optical transceiver installed in an EX Series switch, ensure that you have taken the necessary precautions for safe handling of lasers (see “Laser and LED Safety Guidelines and Warnings for EX Series Switches” on page 213).

To connect a fiber-optic cable to an optical transceiver installed in an EX Series switch:

WARNING: Do not look directly into a fiber-optic transceiver or into the ends of fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to transceivers emit laser light that can damage your eyes.

1.If the fiber-optic cable connector is covered by a rubber safety cap, remove the cap. Save the cap.

2.Remove the rubber safety cap from the optical transceiver. Save the cap.

3.Insert the cable connector into the optical transceiver (see Figure 65 on page 159).

Figure 65: Connecting a Fiber-Optic Cable to an Optical Transceiver Installed in an EX Series Switch

Transceiver

g027016

Fiber-optic cable

4.Secure the cables so that they are not supporting their own weight. Place excess cable out of the way in a neatly coiled loop. Placing fasteners on a loop helps cables maintain their shape.

CAUTION: Do not bend fiber-optic cables beyond their minimum bend radius. An arc smaller than a few inches in diameter can damage the cables and cause problems that are difficult to diagnose.

Do not let fiber-optic cables hang free from the connector. Do not allow fastened loops of cables to dangle, which stresses the cables at the fastening point.

Connecting a Fiber-Optic Cable to an EX Series Switch ■ 159