Juniper Networks EX4200, EX3200 manual Performing Initial Configuration

Chapter 12

Performing Initial Configuration

■Connecting and Configuring an EX Series Switch (CLI Procedure) on page 161

■Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 163

■Configuring the LCD Panel Display on EX Series Switches (CLI Procedure) on page 166

■Setting the Mode on an SFP+ Uplink Module (CLI Procedure) on page 168

Connecting and Configuring an EX Series Switch (CLI Procedure)

There are two ways to connect and configure an EX Series switch: one method is through the console using the CLI and the other is using the J-Web interface. This topic describes the CLI procedure.

Before you begin connecting and configuring an EX Series switch through the console using the CLI:

■Set the following parameter values in the console server or PC:

■Baud Rate—9600

■Flow Control—None

■Data—8

■Parity—None

■Stop Bits—1

■DCD State—Disregard

■To run the ezsetup script, the switch must have the factory default configuration. If you have configured anything on the switch and want to run ezsetup, revert to the factory default configuration. See Reverting to the Default Factory Configuration for the EX Series Switch.

Connecting and Configuring an EX Series Switch (CLI Procedure) ■ 161