Juniper Networks EX3200, EX4200 manual Pin Signal Description

Complete Hardware Guide for EX3200 and EX4200 Ethernet Switches

■See Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch for port location.

■See Routing Engine (RE) Module in an EX8216 Switch for port location.

■Connecting an EX Series Switch to a Management Console on page 153

Management Port Connector Pinout Information for an EX3200 or EX4200 Switch

The management port on an EX3200 or EX4200 switch uses an RJ-45 connector to connect to a management device for out-of-band management.

The port uses an autosensing RJ-45 connector to support a 10/100/1000Base-T connection. Two LEDs on the port indicate link/activity on the port and the administrative status of the port. See “Management Port LEDs in EX3200 and EX4200 Switches” on page 24.

Table 17 on page 42 provides the pinout information of the RJ-45 connector. An

RJ-45 cable, with a connector attached, is supplied with the switch.

Table 17: Management Port Connector Pinout Information for an EX3200 or EX4200 Switch

Pin	Signal	Description
1	TRP1+	Transmit/receive data pair 1
2	TRP1-	Transmit/receive data pair 1
3	TRP2+	Transmit/receive data pair 2
4	TRP3+	Transmit/receive data pair 3
5	TRP3-	Transmit/receive data pair 3
6	TRP2-	Transmit/receive data pair 2
7	TRP4+	Transmit/receive data pair 4
8	TRP4-	Transmit/receive data pair 4

Related Topics ■ See Rear Panel of an EX3200 Switch on page 9 for port location.

■See Rear Panel of an EX4200 Switch on page 11 for port location.

■Connecting an EX Series Switch to a Network for Out-of-Band Management on page 152

42■ Management Port Connector Pinout Information for an EX3200 or EX4200 Switch