Juniper Networks EX4200 manual Chassis Status LEDs in EX3200 Switches

Chapter 2: Component Descriptions

■SFP+ transceiver

■XFP transceiver

NOTE: Uplink modules are not part of the standard package and must be ordered separately.

The power supply, fan tray, uplink module, and transceivers are hot-removable and hot-insertable: You can remove and replace them without powering off the switch or disrupting switch functions.

NOTE: If you have a Juniper J-Care service contract, register any addition, change, or upgrade of hardware components at https://www.juniper.net/customers/csc/management/updateinstallbase.jsp. Failure to do so can result in significant delays if you need replacement parts. This note applies if you change the type of power supply or add a new type of uplink module. It does not apply if you replace these components with the same type of component.

Related Topics ■ Uplink Modules in EX3200 and EX4200 Switches on page 33

■Installing a Power Supply in an EX3200 or EX4200 Switch on page 130

■Removing a Power Supply from an EX3200 or EX4200 Switch on page 172

■Installing a Fan Tray in an EX3200 or EX4200 Switch on page 132

■Removing a Fan Tray from an EX3200 or EX4200 Switch on page 174

■Installing an Uplink Module in an EX3200 or EX4200 Switch on page 133

■Removing an Uplink Module from an EX3200 or EX4200 Switch on page 175

■Installing a Transceiver in an EX Series Switch on page 136

■Removing a Transceiver from an EX Series Switch on page 177

Chassis Status LEDs in EX3200 Switches

The front panel of an EX3200 switch has three LEDs on the far right side of the panel, next to the LCD panel (see Figure 9 on page 17).

Figure 9: Chassis Status LEDs in an EX3200 Switch

Chassis Status LEDs in EX3200 Switches ■ 17