Lucent Technologies Comcode 108678723 manual ATM-CES administration procedure

DEFINITY ECS Release 8.2 ATM Installation,	Issue 1
Upgrades, and Administration 555-233-124	April 2000

5Administering ATM-PNC and ATM-CES

Administering DEFINITY ECS 5-12

ATM-CES administration procedure

Table 5-8 contains ATM-CES administration for

■ATM signaling groups

■ATM-CES direct-connect configurations (two CES circuit packs linked by fiber, with no intervening switches). Observe the note in step 16.

NOTE:

The screens shown are for a Release 8r platform. The screen numbers may differ for Release 8c, Release 8csi, and Release 8si platforms.

Table 5-8. ATM-CES administration

√	Step	Action	Description
	1.	Set the software	Type change system-parameters customer-options and
		version	press Enter. (init login required)
			The Customer Options screen (Screen 5-2) displays.
	2.	Set the version field	Upgrades only: Set the G3 Version field to V8.
			Go to screen 2
	3.	Turn on ATM trunking	Set the Async. Transfer Mode (ATM) Trunking?
			field to y (Screen 5-2).
			Go to screen 3.
	4.	Administer as	Set the ISDN-PRIfield to y (Screen 5-3).
		ISDN-PRI	Press Enter to save the changes.
	5.	Log off/on	Log in as craft
	6.	Install the circuit	Install the TN2305/TN2306 circuit pack and wait for it to
		packs	initialize (about 4 minutes )
	7.	Connect the fiber	Attach the fiber optic cable to the circuit pack and to the
		optic cable	ATM switch.
	8.	Look up ATM circuit	Type list configuration atm and press Enter. The name
		pack locations	for this circuit pack appears as ATM INTERFACE (or ATM
			INTF).
	9.	Administer the circuit	Type add atm trunk-boardUUCSS and press Enter. The
		pack personality	ATM Trunk-Board screen (Screen 5-5) displays.
	10.	Type a name for the	Type the name of the ATM interface circuit pack
		ATM board	(15 alphanumeric characters) in the Name field.