Lucent Technologies Comcode 108678723 manual ATM-CES administration Step Action Description

DEFINITY ECS Release 8.2 ATM Installation,	Issue 1
Upgrades, and Administration 555-233-124	April 2000

5Administering ATM-PNC and ATM-CES

		Administering DEFINITY ECS		5-13
Table 5-8. ATM-CES administration —
	√	Step	Action	Description
		11.	Set the	Set the Synchronization Capable field to n (default).
			synchronization
					NOTE:
					Up to 44 boards may be designated
					synchronization capable on R8r and 3 boards on
					R8si, R8csi, R8c. If you enter y in this field when the
					maximum number of boards has been designated,
					the system returns:
					Maximum number of Synchronization
					Capable boards already administered
					NOTE:
					If this ATM trunk circuit pack is a synchronization
					source, set the field to y. If you change the field to n
					when the circuit pack is administered as a
					synchronization source, the system returns:
					Cannot remove synchronization source.
		12.	Administer the	Type add signaling-groupand press Enter. The Signaling
			signaling group	Group screen (Screen 3-3) displays.
				Set the following fields (tabbing goes vertically)
		13.	Set the group type	Set the Group Type field to atm.
		14.	Type port address	Type the D-channel(signaling channel) port address for
				this new signaling group in UUCSSppp screen at (3-digits
				required for port addresses). This address must match the
				slot and port number on an ATM-Interface circuit pack.
		15.	Type a name	Type a name in the Name field (15 alpha-numeric
				characters).
		16.	Set VPI	The Virtual Path Identifier (VPI) field is set to 0
				and is not administrable.