Lucent Technologies Comcode 108678723 manual KHz

DEFINITY ECS Release 8.2 ATM Installation,	Issue 1
Upgrades, and Administration 555-233-124	April 2000

5Administering ATM-PNC and ATM-CES

		Administering DEFINITY ECS		5-14
Table 5-8. ATM-CES administration —
	√	Step	Action	Description
		17.	Set VCI	Set the Virtual Channel Identifier (VCI) field
				(32-1023). This number must be unique among signaling
				groups that share the same ATM circuit pack.
					NOTE:
					For a direct connection (two fiber-connected CES
					circuit packs), specify the same VCI at both ends of
					the emulated circuit. When the CES is connected to
					an ATM switch, the VCI specified here must match
					the VCI used for the PVC created on the ATM switch,
					which is typically provided by the ATM switch
					administrator.
					NOTE:
					The Signaling Mode field is set to isdn-pri and
					is not administrable.
		18.	Set idle code	Set the Idle Code field (typically 11111111).
		19.	Set interface	Set the Interface Companding field (alaw or mulaw).
			companding	Once administered, busyout the signaling group before
				changing.
		20.	Set country protocol	Set the Country Protocol field (Table 5-9).
		21.	Set protocol version	Set the Protocol Version field (Table 5-9).
		22.	Set circuit type	Set the Circuit Type field (T1 or E1).
					NOTE:
					Both ends must be the same. It is preferable to set it
					to E1 even in the United States, Canada, or other T1
					countries.
		23.	Set connect	Set the Connect field to pbx. Once administered, busyout
				the signaling group before changing.
		24.	Set interface	Set the Interface field to user at one end of the
				emulated circuit and to network at the other end.
		25.	Set DCP/analog	Set the DCP/Analog Bearer Capability field to
			bearer capability	3.1 kHz.
		26.	Set internetworking	Set internetworking message field to PROGress.
			message