Lucent Technologies Comcode 108678723 manual Splitter descriptions

DEFINITY ECS Release 8.2 ATM Installation,	Issue 1
Upgrades, and Administration 555-233-124	April 2000
3 Installing a DEFINITY ECS ATM-PNC
Synchronization Installation and Testing	3-5

Installing and testing the synchronization splitter involves interrupting the DS1 signal provided by the service provider. Even though the DS1 circuit pack should be down less than 5 minutes, before removing a working T1/E1 span, contact the service provider. Failure to notify the T1/E1 service provider may result in:

—The service provider looping the T1/E1 span back to the subscriber.

—A span alarm being detected at the central office and the span being taken out of service, sending an AIS (blue Alarm) to the DEFINITY ECS. The synchronization signal is necessary for testing equipment and connections.

Splitter descriptions

Table 3-2 describes the 4 splitter models and their capabilities. The drawings show the splitters and their connection points. Figure 3-5 shows a schematic of the 2 jumper sets and their connections for 401A, 402A, and 403A sync splitters.

Table 3-2. Synchronization splitter models and attributes

Model	T1/E1	Impedance	Comcode	Drawing	Description/Application
400A	T1	100 Ω	108217795	Figure 3-1	No ICSU capability
401A	T1	100 Ω	108508078	Figure 3-2	Limited ICSU capability
402A	E1	120 Ω	108508094	Figure 3-3
403A	E1	75 Ω	108508102	Figure 3-4