Lucent Technologies Comcode 108678723 manual Field descriptions, List measurements atm pnc-latency

DEFINITY ECS Release 8.2 ATM Installation,	Issue 1
Upgrades, and Administration 555-233-124	April 2000
6 Troubleshooting
Troubleshooting ATM-PNC	6-42

change atm pnc-pairs

PNC MEASUREMENTS PAIRS

Pair	Orig	Dest
	PN	PN
1	1	5
2	1	8
3	5	8
4	5	7
5	4	2
6	10	11
7	10	12
8	10	1
9	1	10

Screen 6-16. PNC measurements pairs screen (change/display atm pnc-pairs)

Field descriptions

Pair Identifies the port network pair number (read only).

Orig PN These entries identify the originating port network and the

Dest PN destination port network for the measured SVCs (values are between 1 and 44; default is blank).

list measurements atm pnc-latency

This command reads and displays the collected information regarding ATM cell latency and connection times. The command-line syntax is:

■list measurements atm pnc-latency [last-hour,today-peak,yesterday-peak] [print schedule]

NOTE:

If a PN pair is changed during a 24-hour period, the peak value reported for the (new) pair is the highest latency measured after the change. If you type list measurements atm pnc-latencyand press Enter while the PNC duplication feature is disabled, the output contains data for A-PNC only.

Measurements are displayed only for administered pnc-pairs. That is, if 5 pairs were administered on the ATM PNC Measurements Pairs screen, the list measurements atm pnc-latencyoutput consists of 5 measurement entries. If the system time has been modified through the set time command during any measurement hour Y, that measurement hour is displayed as Y** instead of Y00, to indicate that the data for that hour may be invalid.