Lucent Technologies Comcode 108678723 manual Changing the port-to-channel mapping

DEFINITY ECS Release 8.2 ATM Installation,	Issue 1
Upgrades, and Administration 555-233-124	April 2000

5Administering ATM-PNC and ATM-CES

Administering DEFINITY ECS 5-22

Changing the port-to-channel mapping

Use the following steps to change the port-to-channel mapping for emulated circuits:

1.Type busyout atm signaling-group siggrpnbr and press Enter to busyout the signaling group.

2.Type change trunk-group trkgrpnbr and press Enter. Remove any port administration on screen 6.

3.Type change signaling-group siggrpnbr. Modify the port-to-channel mapping.

4.Type change trunk-group trkgrpnbr and press Enter.

Add the ports back in on screen 6, using new port numbers, if desired.

5.Type release atm signaling-group siggrpnbr and press Enter to release the signaling group.

The display shows the command aborts, but the D-channel and B-channelscome up.

DEFINITY commands for CES

Administration commands that are useful in working with CES are listed in Table 5-10.

Table 5-10. ATM administration commands

Command	Description
display circuit-packs cabinet	Displays the packs in the cabinet, identifying ATM Trunk as
	well as ATM PNC EI boards. ATM Interface boards have not
	been specified as CES or PNC yet.
display atm ports eqloc	Displays the 256 ports on the ATM board with the
	corresponding signaling and trunk group.
list configuration atm	Lists the ATM boards, identifying equipment location, board
	code, type, and vintage.
list configuration trunks	Lists boards identifying assigned ports. Although the ATM
	board is listed, the 256 ports are not.