Lucent Technologies Comcode 108678723 manual Command Complete displays

DEFINITY ECS Release 8.2 ATM Installation,	Issue 1
Upgrades, and Administration 555-233-124	April 2000
3 Installing a DEFINITY ECS ATM-PNC
Synchronization Installation and Testing	3-25

To configure the 316X CSU to send an AIS blue alarm, use the procedures in

Table 3-12.

Table 3-12. Configuring the 316X CSU to send AIS blue alarm

√	Step	Action	Description
	1.	Configure CSU	At the 316X CSU press the double-up arrow
	2.	Go through the	Press the button under “Cnfig.”
		readout steps
	3.	Continue	Press the button under “Activ.”
	4.	Continue	Press the button under “Edit.”
	5.	Continue	Press the right arrow until “GEN” displays.
	6.	Continue	Press the button under “GEN.”
	7.	Continue	Press F1 (“Next”) until “Gen Yellow Alarm” displays. (This
			option defaults as enabled.)
	8.	Continue	Press the button under “Disabled.”
	9.	Continue	Press the double-up arrow.
			Save Option displays when “Enabled” changes to
			“Disabled.”
	10.	Save settings	Press the button under the word “Yes” at the “Save
			Options Yes or No” prompt. Otherwise press F1 twice.
	11.	Save options	Press the button under “Activ” when asked where to save
			the options.
			Command Complete displays.
	12.	Return to default	The CSU times out to its default ESF CSU Operational
		screen	screen or set it there by pressing the double-up arrow
			once and then pressing F1 twice.
	13.	Install the splitter	Go to Table 3-13 to install the splitter.

NOTE:

All four faceplate status LEDs on the DS1 circuit pack are dark (not lit) when using an external CSU or DSU/CSU. The STATUS LEDs on the DS1 circuit pack are only functional with a 120A ICSU.