Lucent Technologies merlin messaging system

Setting the Outcalling Lines to No Ring

If the communications system is operating in Key Mode and Outcalling is used, the outside line(s)

assigned to the MERLIN Messaging System voice port(s) that are used for Outcalling must be set to No

Ring. This procedure is not necessary if the communications system is operating in the Hybrid/PBX mode.

For MERLIN Messaging System Release 2 or later, the voice port(s) used for Outcalling are Port 2 on a

2-port system, Port 4 on a 4-port system, Ports 5 and 6 on a 6-port system, Ports 7 and 8 on an 8-port

system, Ports 9 and 10 on a 10-port system, or Ports 11 and 12 on a 12-port system. For Release 1 or 1.1,

the voice port used for Outcalling is Port 2 on a 2-port system, Port 4 on a 4-port system, or Port 6 on a

6-port system.

Setting the Outcalling Line to No Ring:

Step Programming Task Console Input/Selection PC Input/Selection

1Enter programming mode

Sys Program

Exit/Start

[any key]

2Display next page of menu /

3Select Centralized Telephone

Programming Cntr-Prg

4Select Program Extension Program Ext

5Enter the extension you want to

program [nnn] Enter [nnn]

6Start Centralized Telephone

Programming Start

7Select the line/feature button

representing the Outcalling line Press button on console

or +

function key, then

8Select Ring Options for all lines or

ListFeature

Ring Options

All Lines

Enter

No Ring

Setting the Outcalling Lines to No Ring

http://www.sostc.com/lucent/installation/programming_communication/mmipcpmp6.htm (1 of 2) [2/2/2000 2:32:27 PM]