Changing Calling Restrictions to Allow Outcalling
If Then
The Outcalling feature is not used The communications system extensions assigned to MERLIN
Messaging System module voice ports should be Outward
Restricted.
The Outcalling feature is used For Release 2 or later, Program the apppropriate ARS FRL for each
messaging port extension as follows:
Port 2 only on a 2-port system●
Port 4 only on a 4-port system●
Ports 5 and 6 only on a 6-port system●
Ports 7 and 8 only on a 8-port system●
Ports 9 and 10 only on a 10-port system●
Ports 11 and 12 only on a 12-port system●
For Release 1 and 1.1, ports to be unrestricted or toll restricted are:
Port 2 only on a 2-port system●
Port 4 only on a 4-port system●
Port 6 only on a 6-port system●
Note:
The factory setting for all the MERLIN Messaging System extensions assigned to
the MERLIN Messaging System Calling Group VMI are Outward Restricted.
●
Refer to your communications System Planning Form containing Call Restrictions
and Lists information to identify the Outward Restriction status of extensions at
your site.
●
To Change the Calling Restrictions to Allow Outcalling
Step To… Console Input/Selection PC Input/Selection
1Enter programming mode
Sys Program
Exit/Start
[any key]
2Select Extensions Extensions
3Select Restriction Restriction
4Enter the extension number of the
highest MERLIN Messaging
System port
[nnn]
Enter
[nnn]
Changing Calling Restrictions to Allow Outcalling
http://www.sostc.com/lucent/ongoingmaintenance/portlicensing/mmipcpcs5a.htm (1 of 2) [2/2/2000 2:35:42 PM]