Philips 200 manual Condensation, Air Filter, Cooling Air Vents, Battery Life, Detachable Battery

9

Operating	The device may only be operated at temperatures between 5˚ C and
and Storage	40˚ C (41˚ F and 104˚ F).
Temperatures	Do not operate the device in direct sunlight or near a heating
	appliance because these conditions can increase the temperature of
	the airflow delivered to the patient.
	Prolonged operation or storage at elevated temperatures may reduce
	the service life of the battery and other internal components of the
	ventilator.
	The ventilator has an internal and detachable Lithium-Ion Battery. Do
	not expose the device or detachable battery to temperatures above
	40˚ C (104˚ F) during use, or above 60˚ C (140˚ F) during storage. This
	will reduce battery life and may increase the risk of fire or damage the
	battery.
Condensation	Condensation may affect operation or accuracy of the device. If the
	device has been exposed to either very hot or very cold temperatures
	during storage, allow it to adjust to ambient temperature before
	starting therapy.
Air Filter	The reusable foam inlet filter is required to protect the ventilator from
	dirt and dust. Wash periodically and replace when damaged for proper
	operation.
Cooling Air Vents	Do not block the cooling air vents located on the base and the rear
	of the device. This may cause the device to overheat in high ambient
	temperatures or at high therapy settings.
Battery Life	The internal and detachable batteries wear out based on the amount
	of use (hours or full charge-discharge cycles). The battery capacity and
	life are also reduced by operation at higher temperatures.
Detachable Battery	Only use the Philips Respironics Trilogy Detachable Battery with the
	ventilator.
Cleaning	Do not steam autoclave the ventilator. Doing so will destroy the
	ventilator.
	Do not immerse the device in liquid or allow any liquid to enter the
	enclosure or inlet filter.
	Do not spray water or any other solutions directly onto the ventilator.
	Do not use harsh detergents, abrasive cleaners, or brushes to clean the
	ventilator system. Use only cleaning agents and methods listed in this
	manual.

Chapter 1 Introduction