Chapter 2 - Setting Up Your System Hardware
Installing Batteries in the Remote Control
The remote control uses three AAA batteries, which are included with the system.
To install batteries in the remote control:
1.Remove the battery cover from the back of the remote control.
2.Refer to the diagram inside the remote control, and install the batteries in the orientation shown.
3. Reinstall the battery cover on the remote control.
Connecting Power
The V500 system has an external power supply.
Do not use a power supply other than the one supplied with your V500 system. Using the wrong power supply will void the warranty and may damage your system.
To connect power and power on the system:
1.Connect the power supply to the power connector on the back of the system.
2.Connect the power cord to the power supply.
Do not connect the V500 system power cord to a wall outlet until you have connected all equipment to the system.
3.Press the power switch located at the back of the system.
BRI | LAN |
Power connector | Power switch |
© Polycom, Inc. | 2 - 5 |
