Chapter 5 - Managing the System Remotely
Room Monitoring with the V500 Web Interface
The Web Director feature within the V500 web interface allows administrators of the V500 system to monitor a call or the room where the system is installed.
For security reasons, this feature can only be enabled on the local system by an administrator.
To enable room monitoring:
1.Go to System > Admin Settings > General Settings > Security.
2.Select Allow Video Display on Web to allow the room to be viewed remotely.
To view a room:
1.On a PC, open a web browser.
2.In the browser address line, enter the system’s IP address (for example, http://255.255.255.255) to go to the V500 web interface.
3.Go to System Setup > Utilities > Web Director.
4.Perform any of the following tasks:
•Place or end a call
•View near and far sites
•Adjust system volume settings
•Mute and unmute the microphone
© Polycom, Inc. | 5 - 3 |
