A

Performing Diagnostics Running Loopback and Read/Write Buffer Diagnostic Tests

To resume normal adapter operations:

1.Remove the loopback connector from the adapter connector.

2.Reconnect the cable that you disconnected in “Installing a Loopback Connector” on page 6-4.

3.Modify the adapter settings Connection Options back to its previous setting (see “Modifying the Adapter Settings Connection Options Setting” in the help system).

Preparing for the Read/Write Buffer Test

The read/write buffer test must be run on a device (disk or tape). Before running the read/write buffer test, verify that the adapter port is connected to at least one device by viewing the SANsurfer FC HBA Manager FC/CNA HBA tree.

NOTE:

Some devices may not support Read/Write Buffer commands. Check with your hardware vendors or manufacturer.

You can run the read/write test on all devices attached to the adapter port or to specific devices attached to the adapter port.

To prepare for the read/write buffer test for all devices attached to an adapter port:

1.In the SANsurfer FC HBA Manager FC/CNA HBA tree, right-click an adapter port.

2.On the shortcut menu, point to Device Diagnostics, and then click Enable All Devices.

A check mark appears next to all the device icons attached to the selected adapter port.

To prepare for the read/write buffer test for specific devices attached to an adapter port:

1.In the SANsurfer FC HBA Manager FC/CNA HBA tree, right-click a device.

2.On the shortcut menu, point to Device Diagnostics, and then click Enable on Device.

A check mark appears next to the device icon.

3.Repeat for each device you want to test.

SN0054651-00 F

6-5

Page 107
Image 107
Q-Logic SN0054651-00 F manual Preparing for the Read/Write Buffer Test, To resume normal adapter operations