For details of saving and recalling setup data, see “Saving and Recalling Setup Data” (page 148).

System reset and memory initialization (Initialize)

•Reset: Reset to state after powering on.

•All Clear: Clear the memory, and carry out initialization. The Network Config, System Config, Format, and Start Up setup values are set by reference to data stored in non-volatile memory, and the system automatically starts up. It is not necessary to reset the Date/Time settings.

For more details, see “Saving and Recalling Setup Data” (page 148).

Installation (Install)

This installs the software and firmware in all devices (including the DCU) connected to the Data LAN.

Standard Install mode: Installs the standard configuration. There are also the following functions.

Detail Information: Gives details of the software and firmware installed in each device.

Device management (Maintenance)

•Date and time setting

•Formatting a memory card

•Primary settings for USB external storage device

•Reloading a USB driver

Functions 9000-DVS 1 Chapter

Setup 147