2 Press the [Pattern Limit] button, turning it on.

3 Turn the knobs to adjust the following parameters.

Knob

Parameter

Adjustment

Setting values

 

 

 

 

1

Pattern Limit

Pattern limit

0.00 a) to 100.00% b)

a)0.00%: Executing the transition does not change the video output at all.

b)100.00%: The transition is the same as when no pattern limit is set, but the cross-point button selections of the background A and B buses do not interchange when the transition completes.

Executing a pattern limit transition

Use the following procedure.

1 Press the [PTN LIMIT] button, turning it on.

The button you pressed lights amber.

2 Carry out the transition.

The transition progresses as far as the set pattern limit. Even if the transition completes, the cross-point button assignments of the background A and B buses do not interchange.

3 Carry out the transition once again.

The status before the previous transition is restored.

To cancel the pattern limit

To cancel the pattern limit after completion of step 3 of the above procedure, press the [PTN LIMIT] button, turning it off.

If after carrying out step 2 above, the pattern limit has been reached, carry out the following procedure.

1 Press the [PTN LIMIT] button.

The button you pressed lights green.

2 Carry out the transition.

The [PTN LIMIT] button goes off, and the pattern limit state is released. Depending on the way in which the transition was executed, the action will be as follows.

•When you press the [CUT] button, the pattern limit is immediately released, and the image switches instantaneously.

Transitions 3 Chapter

Executing a Transition 241